Welcome to the performance ecosystem. Follow these steps to install your BTA mount and optimize your aero cockpit.
🛠️ REQUIRED HARDWARE
- Screws included:
- 2x M5 x 20mm screws (Base)
- 2x M5 x 40mm screws (Upper stack)
- 2x M5 x 8mm screws (Lower option)
- Tools: Allen key set (2.5, 3, 4mm recommended).
⚙️ STEP 1: CENTER BLOCK ASSEMBLY
Objective: Secure the BTA support plate to the center spacer.
- Align the holes of the BTA support plate with the threads of the center spacer.
- Securely fasten the assembly using the 2 M5 x 20mm screws, tighten to 4nm
- 💡 RocketTT Tip: A medium threadlocker (e.g., Loctite 243) on the screws is recommended for optimal hold against vibrations.
💨 STEP 2: UPPER AERO STACK (VFLOW/BTA)
Objective: Integrate the fairing, computer mount / or a 1cm spacer, and the main bottle cage.
- Stack the components on the center spacer in the following order:
- 👉 VFLOW Aero Support (nose cone)
- 👉 Computer Mount (Garmin/Wahoo spacer) / spacer
- 👉 Main bottle cage.
- Pass the 2 long M5 x 40mm screws through this entire stack. / !\ If you are not using the spacer, use the M5 x 30mm screws / !\
- Screw firmly from the top into the upper threads of the center spacer: Tighten to 4nm
🎒 STEP 3: INSTALLING THE LOWER OPTION
Objective: Attach an accessory or a second bottle cage under the spacer.
- Position your lower bottle cage (or modular accessory type Spares) directly under the center spacer.
- Securely fasten using the 2 short M5 x 8mm screws. Tighten to 4nm
🏁 STEP 4: FINAL INSTALLATION ON THE COCKPIT
Objective: Attach the assembled unit to the bike.
- Position the complete BTA assembly between your cockpit's plate and your armrests.
- Securely fasten using the provided M5 screws.
- Note: A kit of M5 screws of various lengths is provided to adapt to the thickness of your specific stack
- Select the longest possible screw while ensuring a firm tightening without parasitic stops.
Congratulations, your RocketTT cockpit is ready! Check the tightness of all components before your first ride.